1TON biomass steam generator

The steam generator models for LSG1.0-0.7 - M, is a kind of internal combustion five return burning straw briquette fuel of steam generator, furnace set multi-tube cyclone dust removal and two levels of economizer, the penetration of the water tube structure, domestic and international leading level, 4 to 5 minutes after a successful ignition can obtain sufficient pressure steam, is a generation of environmental protection and efficient energy-saving products.

According to TSG G0001-2012 "boiler safety technology supervision regulation" regulation, the design of normal water level water capacity of less than 30 l steam generator does not need to supervise and inspection (does not need to get the certificate of boiler and don't need a license), the steam generator water capacity of less than 30 l, without approval, inspection.

This steam generator adopts automatic microcomputer control system, automatic control of equipment operation, no manual guard, automatic water inlet system. Automatic control pressure system, automatic feeding system. With low water level alarm and stop operation, the overpressure will stop running automatically. It will start operation automatically under the setting pressure, and adopt multiple safety design, which is safe and reliable. The factory has complete configuration, stainless steel multi-stage pump, durable, safe and convenient. Cyclone boiler adopts unique automatic pressure half gasification combustion, a. Secondary air ratio adjustment, rotate to the wind, burning full, membrane type water wall structure, heating surface is big, small water degree, warming produces steam fast. After the combustion, the flue gas has a full cycle, the flue gas heat exchange is sufficient, the smoke exhaust temperature is low, the water supply is two-stage heat exchange, the built-in multi-tube cyclone dust collector, the high efficiency energy saving and environmental protection. Equipped with ladders, equipped with the factory, easy to install, easy to operate, easy to maintain, safe and stable operation cost is lower than the boilers produced by the general manufacturers.

The boiler pressure component adopts the tubular water pipe structure. Confined by top and bottom ring of ontology header and two laps of finned tube cylindrical channels for a return, outer finned tube with inner ring ring channel of finned tube for the second return, outer ring of finned tube and the atmospheric pressure inside the economizer tube annular passage for the third return, water outside the multi-tube cyclone tube channel for the fourth return, dust collector pipe for the return of 5, the energy saving effect is greatly increased.